TEL P8 and P8XL Top Load Prober Interface for a ... - Zzybot.net

InstallationTEL P8 and TEL P8XL Top Load Prober Interface Installation Manual for the Catalyst Test SystemNoteUse proper equipment and care to make sure that you do not exceed theindicated torque values in the Installation section.Figure 3 is an exploded view of a general prober interface assembly.Registration Tool*(pn 480-226-00)TowerAlignment Fixture*(pn 480-047-02)Hinge and Insert Assembly(pn 420-232-03)Guide Pin (X2)(pn 480-018-12)L-Plate(pn 480-083-02)V-Groove Assembly (X3)(pn 804-887-00)Spacers (X3)(pn 480-227-12, -13, -14)Head PlateThe parts marked with an * above are used during installation for aligning the interface tothe prober and are removed proior to docking.Figure 3 TEL Prober Interface Assembly1) Verify that the proper mounting holes and inserts have been installed in the prober headplate before beginning the installation. (The mounting hole locations are the same forTEL P8 and TEL P8XL.) If they are not present, they must be added (see subprocedurebelow and Figure 4).If holes and inserts must be added to the ring carrier, use the following subprocedure:A) Drill (three places) (φ 0.3751 +0.0004/-0.0000) and install the insert bushing (CarrLane (pn CLB-10000 or equivalent) (see A in Figure 4-three places).9