TEL P8 and P8XL Top Load Prober Interface for a ... - Zzybot.net

More documents

Recommendations

Info

TEL P8 and TEL P8XL Top Load Prober Interface Installation Manual for the Catalyst Test System5) Fasten the three spacers A, B, and C (pn 480-227-12, -13, -14) to the L-plate. See Figure6. Each spacer has a small groove and is marked with a letter. Align the letter on thespacer with the corresponding letter on the L-Plate.6) Secure the spacers by tightening the two captive 1/4”-20 screws in each to 30 in-lbs.7) Disassemble the three V-grooves by loosening the four captive #8 screws holding thecovers (set aside for later re-installation) onto the base with the 5/64” hex wrenchsupplied in the registration tool kit.8) Discard the washers and 1/4”-20 screws9) Assemble the two V-groove screws (pn 470-046-16), brass screw sleeves(pn 480-094-00), steel washers (pn 470-080-26) and bronze washers (pn 480-213-00)from the V-groove Upgrade Kit (pn 807-873-00) in the following order: steel washer(against screw head) followed by the bronze washer, steel washer, and brass sleeve. SeeFigure 7. Repeat for all three groove assemblies.V-Groove Upgrade KitFor assembly details seethe illustration to the right.V-Figure 7 Spacer and V-Groove Attachment10) Loosely fasten the V-grooves to the L-plate (on top of the spacers) with two of thescrew assemblies just assembled in Step 9. See Figure 7.11) Mount the hinge insert (pn 420-232-03) to the top side of the head plate. See Figure 8.Align the screw holes in the insert with those in the head plate.12
TEL P8 and TEL P8XL Top Load Prober Interface Installation Manual for the Catalyst Test SystemOperator SideHinged Insert(pn 420-232-03)M5 Flat Head Screw (X5)(pn 470-481-05)Figure 8 Insert Attachment To Head Plate12) Secure the hinge insert to the piston stop by tightening the five M5 flat head screws (pn470-481-05) to 30 in-lbs.13
Page 1 and 2: TEL P8 and P8XL Top LoadProber Inte
Page 3 and 4: About this ManualTEL P8 and TEL P8X
Page 5: TEL P8 and P8XL Top Load Prober Int
Page 8 and 9: TEL P8 and TEL P8XL Top Load Prober

TEL P8 and P8XL Top Load Prober Interface for a ... - Zzybot.net

Create successful ePaper yourself

Delete template?

Save as template?