TEL P8 and P8XL Top Load Prober Interface for a ... - Zzybot.net

More documents

Recommendations

Info

TEL P8 and TEL P8XL Top Load Prober Interface Installation Manual for the Catalyst Test SystemB) Drill (six places) (φ 0.201 ID) and install the insert (Helicoil, 1/4”-20, 0.50” deep)(see B in Figure 4- six places).Figure 4 Head Plate Mounting Holes For L-Plate and InsertNoteSome of these instructions may not pertain to your specific interface. If a stepdescribes a part that is not part of your interface, skip to the next step.NoteHole locations are the same for both the P8 and the P8XL L-Plates.2) Mount the L-Plate (pn 480-083-02) to the prober head plate.Align the three alignment pins on the bottom of the L-Plate with the bushings on the topof the head plate. See Figure 5.10
TEL P8 and TEL P8XL Top Load Prober Interface Installation Manual for the Catalyst Test SystemAlignment pin locatedunderneath the L-PlateAlignment pin locatedunderneath the L-PlateL-Plate(pn 480-083-02)TEL Head PlateAlignment pin locatedunderneath the L-PlateFigure 5 L-Plate Attachment to Head Plate3) Secure the L-Plate to the prober by tightening the six 1/4”-20 captive screws. SeeFigure 5. Ref to Table 8 on page 6 for torque specifications.4) Attach two guide pins (pn 480-018-12) to the L-Plate and tighten to 24 inch-lbs. SeeFigure 6.Guide Pins (X2)(pn 480-018-12)Spacer (X3)(pn 480-227-12, 13, 14)Figure 6 Guide Pin Attachment11
Page 1 and 2: TEL P8 and P8XL Top LoadProber Inte
Page 3 and 4: About this ManualTEL P8 and TEL P8X
Page 5: TEL P8 and P8XL Top Load Prober Int
Page 8 and 9: TEL P8 and TEL P8XL Top Load Prober

TEL P8 and P8XL Top Load Prober Interface for a ... - Zzybot.net

Create successful ePaper yourself

Delete template?

Save as template?