TEL P8 and P8XL Top Load Prober Interface for a ... - Zzybot.net

TEL P8 and TEL P8XL Top Load Prober Interface Installation Manual for the Catalyst Test System19) Slide the V-grooves to roughly the midposition of their range of motion. See Figure 12.See Detail DRegistration Tool(pn 480-226-00)V-grooveDetail DFigure 12 V-Groove PositioningNoteThe outer corner bushings of the registration tool allow the loose V-grooves toslide into position, aligning the center of the prober with the center of the testhead DIB. This does not effect alignment or repeatability. To prevent anychance of binding during latching, the V-grooves can simply be moved toapproximately the middle of their range of motion along the V-groove trough.NoteWhen performing Step 20 and Step 21, do not touch the registration tool.20) Reach down through the access holes in the corners of the registration tool with theT-wrench and tighten the two 1/4”-20 sleeved V-groove lockdown screws. Refer toTable 8 on page 6 for torque specifications.21) Repeat this process for the remaining two V-grooves.22) Carefully lift the registration tool evenly and remove it. Do not lift from only one side.Store the registration tool for future use.23) Remove the triangular fixture and store for future use.17