beaver

BEAVER4.2.2 Connecting the torch holder to themachine(No tool to use)1 Insert the two crossbars from leftto right until the rack and thepinion engages each other.2 Put it forward by pinion handle.Note: When the pinion handle istoo heavy or too smooth, adjustthe movement by the bolt on theaxis under the crossbars.1. Adjusting boltfigure 4 - 14.2.3 Attaching the torch to the torchholder(No tool to use)1 Loosen the wing screw of the torch holder2 Insert the torch from the top. (Best position of the torch is approx. 10mm upper from where the torch is inserted fully.)3 Tighten the screw.4.2.4 Linking the gas distributor with the torch(Tool to use: wrench) Refer to figure 4 - 2.The inlet nipples of the torch are:LongMediumShortJOXPOXGAS (Left screw)The hoses of gas distributor are:Blue valve sideBlue valve sideRed valve sidePOX (RH screw)JOX (middle)GAS (Left screw)18