beaver

BEAVERCautionFor the small circle cutting, increase the speed, but it may not bepossible to cut a very thin plate because of the speed limitations.Radius limit of the machine with the standard equipment is: minimum50 mm, maximum 550 mm.How to pierce1 Ignite a torch.2 Adjust the flame.3 After heating the point until it has become quite incandescent, pushthe jet oxygen valve to get the cutting oxygen and the hole will beproduced quickly.To avoid the slag fouling the tip, use the up and down handle of the torchholding bracket to lift the torch about 10 mm.5.6.4 Optional circle cuttingSetting of the machine is different in large and small circle cutting. See thediagram and set the optional equipment as follows.Note: Set the corner so that it lies on the prolongation of the drivingwheel axis.~ 2 mm50 mm~ 2 mm550 mmfigure 5 - 41 Fix the circle-cutting bar in the hole provided in front of the gearcase.27