beaver

BEAVERThe jet oxygen valve should be open completely in advance when it isactuated. When the gas pressure is high to cut a thin plate, use this valveto reduce the pressure in order to make the cutting operation easy.CautionBe sure not to leave any dust and if there is any remove itimmediately. If there is any large dust or spatter on the rail, themachine will suffer from knocking there and it will cause the damageof the cutting surface.CautionBe careful not to allow the hoses catch on the plates edge.5.6.2 Manual guide cutting1 Do the marking off on the plate surface and make a punch markwherever curved and straight lines join.2 While shifting the machine handle, approach the tip to the position30 ~ 50mm from the side of the drive wheel.3 Free the guide wheel by pulling the clutch lever with a forefinger andmove the machine to the cutting start point.4 Arrange hoses so that they will not bother the cutting operation.5 Heat the starting point thoroughly.6 Open the jet oxygen lever by the thumb.7 Turn the power switch immediately and guide the machine by handso that the tip trace the marking off line.8 Let the machine run only by the drive motor (do not pull or push themachine forward) and give the machine only the direction by hand.1. Outside cuts(increase speed)2. Inside cuts(decrease speed)3. Tip312figure 5 - 325