MODEL V2648XL, V2648 - MinnPar

• PUMPMOTORThe CONDOR® model V2648/53XLutilizes a pump motor which is a 24 volt DC unit,rated 6 hp @ 3600 rpm. Since the model V2648153XL utilizes a gravity lowering system, themotor does not run while the lowering function isactivated.PumplMotorContactorFIG. 10LOWER CONTROL FUNCTIONSLocated above the left rear wheel is thelower control box, which provides a junctionconnection through the use of two terminal strips,for the limit switch cable, the hydraulic valvecable, the pump motor contactor cable, and thecable to the upper controls. At the lower controlsare switches (see FIG. 11), to provide operationof the lift function only; drive is not availablefrom this control box. The lower control boxcontains an emergency stop button which must bepulled out to supply power to both control boxes.The control selector switch is a 3-position maintainedrotary switch that directs power to eithercontrol box for operation of the machine,Emergency Stop ButtonPlatform Lift Control ---";I!+--L....LControl Selector Switch ---jft-+-+-~., J OFF :"""--------':_-l!IH--@ :15 Amp Circuit BreakerlFuse" ,~ ___________ JFIG. 11while the box not selected, will not have power. The platform lift control consists of two pushbuttons,which, through the use of contact blocks, energize the pump motor and selector valve for raising, or theholding valve for lowering. The pump motor does not run during lowering.UPPER CONTROL FUNCTIONSThe upper control box, located at the right hand forward comer of the platform, is a fiberglassenclosure which contains two slip-fit inserts on its underside that allow the box to press onto two pinswhich are part of the platform weldment. The control box is removeable by disconnecting the cableharness plug underneath, and lifting upward on the box assembly. The feature allows for disabling themachine, storage of the box, or ease of repair to the controls. Some of the controls used are identical tothe those found at the lower control box (See FIG. 12), primarily the emergency stop button and the liftcontrols. The platform lift control buttons operate similar to the lower control pushbuttons. However,at this control box, the green "POWER ff pushbutton must be depressed to supply power to either the raiseor lower lift button. To provide electrical power to the upper control box, both emergency stop buttonsmust be in the "out" position, the control selector switch must be in the "UPPER" position.MANUAL 92357-002JUNE 1997