GM 3000AC - WAGNER-Group

EDITION 05/2007OPERATING MANUALPART NO. DOC364831GM 3000AC5.4.4 CLEANING AIRCOAT NOZZLESFor disassembly and assembly see AirCoat nozzles section 5.4.3.The AirCoat nozzle (C) can be placed into a cleaning solvent which has been recommendedby the paint manufacturer.5.4.5 UNBLOCKING CLOGGED NOZZLE1. Relieve the pressure from the gun and unit.2. Secure gun with trigger safety catch.3. Unscrew aircap nut with nozzle guard (A).4. Remove aircap (B).5. Pull out the clogged nozzle (C) from the air cap (B), reverse it and replace it into nozzle seal(D).6. Place air cap (B) on the nozzle (C). Take care that the nozzle fitted is correctly(see flats X)7. Fit the aircap nut with nozzle guard (A) over the air cap (B) onto the spray gun andtighten by hand.8. Switch the material pressure back on.9. Turn the safety catch to the spraying position and briefly pull trigger.10. When the blockage has been flushed out secure the gun with safety catch.11. Relieve the pressure from the gun and unit.12. Unscrew aircap nut with nozzle guard (A).13. Remove air cap (B) and reverse nozzle (C) again.14. Refit air cap (B) on the nozzle (C). Take care that the nozzle fitted is correctly (see flatside X)15. Fit the aircap nut with nozzle guard (A) over the air cap (B) onto the spray gun andtighten by hand.16. Switch the material pressure and the air pressure back on.XNozzle in „spray“ positionDABCB_00039Nozzle in „cleaning“ position28