Guppy Technical Manual V7.1.0 - Allied Vision Technologies

Introduction
Version Date Remarks
V7.0.0 31.10.08
continued from last page
Operating temperature changed from 50 °C to 45 °C for all
Guppy types in Chapter Specifications on page 29ff.
New Guppy camera photos with new camera naming font:
Title page
New Guppy F-503B/C: Read information in the following sections:
Chapter Declarations of conformity on page 24f.
Table 5: Focal width vs. field of view (Guppy F-503) on
page 27
Chapter Specification Guppy F-503B/C on page 51f.
Chapter Horizontal and vertical mirror function (only
Guppy F-036/F-503) on page 114
Chapter White balance on page 114ff.
Chapter Manual gain on page 122
Chapter Brightness (black level or offset) on page 126
Chapter Look-up table (LUT) and gamma function on page
131f.
Chapter Binning (only Guppy F-036B and Guppy F-503B/
C) on page 138ff.
Chapter Packed 12-Bit Mode on page 153.
This mode is not yet available for Guppy F-503B/C.
Chapter Exposure time (shutter) and offset on page 181ff.
Table 65: Camera-specific exposure time offset on page
182
Figure 104: Data flow and timing after end of exposure
(Guppy F-038/044 also NIR) on page 186
Table 70: Jitter at exposure start on page 188
Table 80: Video formats Guppy F-503B / Guppy F-503C on
page 198
GUPPY F-503: AOI frame rates on page 217
Table 111: Camera type ID list on page 258
For Guppy F-503B/C output switching times (tp and min.
shutter) see Hardware Installation Guide, subsection Guppy
delay.
to be continued on next page
Table 1: Document history
GUPPY Technical Manual V7.1.0
16