Guppy Technical Manual V7.1.0 - Allied Vision Technologies

Introduction
Version Date Remarks
V7.1.0
[continued]
07.05.09
[continued]
Manual overview
continued from last page
[continued]
Offset of low noise binning mode changed from 0xF1000580 to
0xF10005B0 in Table 132: Advanced register: Low noise binning
mode on page 281.
Changed Camera In 1 signal Uin (high) from 2 V to 2.4 V in Figure
33: GUPPY (housing): Camera I/O connector pin assignment
on page 76
Corrected HUE and SATURATION in Feature control register to
Always 0 (for b/w and color cameras) on page 251 (TestTrack
Defect 605)
Calculated effective chip size for all sensors (with resolution
of Format_7 Mode_0) in Chapter Specifications on page 29ff.
Due to discontinuation: removed Guppy F-025/029 cameras in
Chapter Guppy cameras on page 23
Chapter Declarations of conformity on page 24f.
Chapter Specifications on page 29ff.
Chapter Video formats, modes and bandwidth on page
190ff.
Chapter Description of the data path on page 98ff.
Chapter Controlling image capture on page 167ff.
Corrected drawing in Figure 121: Delayed integration timing on
page 270
Table 1: Document history
This manual overview describes each chapter of this manual shortly.
Chapter Contacting Allied Vision Technologies on page 9 lists AVT contact
data for both:
– technical information / ordering
– commercial information
Chapter Introduction on page 10 (this chapter) gives you the document
history, a manual overview and conventions used in this manual (styles
and symbols). Furthermore you learn how to get more information on
how to install hardware (Hardware Installation Guide), available AVT
software (incl. documentation) and where to get it.
Chapter Guppy cameras on page 23 gives you a short introduction to the
GUPPY cameras with their FireWire technology. Links are provided to
data sheets and brochures on AVT website.
GUPPY Technical Manual V7.1.0
18