Guppy Technical Manual V7.1.0 - Allied Vision Technologies

More documents

Recommendations

Info

Specifications Feature Specification Regulations Board level cameras are not tested for compliance with the regulations due to the fact that test results are strongly dependent on the housing. Optional accessories C-Mount (built-in IR cut filter / protection glass) M12-Mount (built-in IR cut filter / protection glass) M12 lenses 1394 adapter cable I/O adapter cable Software packages AVT FirePackage (SDK and Viewer, 100% control the bus) AVT Direct FirePackage (SDK and Viewer, compatible to DirectX and WDM) AVT Fire4Linux (SDK and Viewer, compatible to RedHat and Suse Distributions) Table 8: Specification Guppy F-033B/C BL (board level) Note � The design and specifications for the products described above may change without notice. GUPPY Technical Manual V7.1.0 32
Specifications Guppy F-036B/C Feature Specification Image device Type 1/3 (diag. 5.35 mm) progressive scan Micron/Aptina CMOS MT9V022 with microlens Effective chip size 4.5 mm x 2.9 mm Cell size 6.0 µm x 6.0 µm Lens mount C-Mount: 17.526 mm (in air), Ø 25.4 mm (32 tpi), mechanical flange back to filter distance: 9.5 mm (see Figure 29: Guppy C-Mount dimensions on page 71) CS-Mount: 12.526 mm (in air), Ø 25.4 mm (32 tpi), mechanical flange back distance: 8 mm (see Figure 30: Guppy CS-Mount dimensions on page 72) Picture size (max.) 752 x 480 pixels (Format_7 Mode_0) ADC 10 bit Frame rates 15 fps; 30 fps; 60 fps variable frame rates in Format_7 from 10 fps up to 64 fps Gain control Manual: 0-12 dB (average ~0.25 dB/step) for details see Chapter Manual gain on page 122 Shutter speed 179 µs … ~979 ms External trigger shutter Trigger_Mode_0, trigger delay Look-up table One, user programmable (10 bit � 8 bit); gamma (0.5) Smart functions AGC (auto gain control), LUT (look-up table), mirror, only b/w: binning (average) only color: AWB (auto white balance) one configurable input, three configurable outputs RS-232 port (serial port, IIDC V1.31) Transfer rate 100 Mbit/s, 200 Mbit/s, 400 Mbit/s Digital interface IEEE 1394a IIDC V1.3, single port Power requirements DC 8 V - 36 V via IEEE 1394 cable or 8-pin HIROSE Power consumption Less than 2 watt (@ 12 V DC) Dimensions 48.2 mm x 30 mm x 30 mm (L x W x H); w/o tripod and lens Mass 50 g (without lens) Operating temperature + 5 °C ... + 45 °C housing temperature (without condensation) Storage temperature - 10 °C ... + 60 °C ambient temperature (without condensation) Regulations FCC Class B, CE, RoHS (2002/95/EC) Table 9: Specification Guppy F-036B/C GUPPY Technical Manual V7.1.0 33
Page 1 and 2: Allied Vision Technologies GmbH Tas
Page 3 and 4: Contents Contacting Allied Vision T
Page 5 and 6: How demosaicing works .............
Page 7 and 8: GUPPY F-033 and board level version
Page 9 and 10: Contacting Allied Vision Technologi
Page 11 and 12: Introduction Version Date Remarks c
Page 13 and 14: Introduction Version Date Remarks V
Page 19 and 20: Introduction Chapter Declarations o
Page 21 and 22: Introduction More information Befor
Page 23 and 24: Guppy cameras Guppy cameras Guppy W
Page 25 and 26: Declarations of conformity Note �
Page 27 and 28: Filter and lenses Camera lenses Foc
Page 29 and 30: Specifications Specifications Note
Page 31: Specifications Guppy F-033B/C BL (b
Page 35 and 36: Specifications Guppy F-038B/C Featu
Page 37 and 38: Specifications Guppy F-038B/C NIR F
Page 41 and 42: Specifications Guppy F-044B/C NIR F
Page 47 and 48: Specifications Guppy F-080B/C BL (b
Page 53 and 54: Specifications Spectral sensitivity
Page 55 and 56: Specifications Figure 6: Spectral s
Page 57 and 58: Specifications Figure 10: Spectral
Page 63 and 64: Camera dimensions Camera dimensions
Page 65 and 66: Camera dimensions Guppy standard ho
Page 67 and 68: Camera dimensions Guppy board level
Page 69 and 70: Camera dimensions Guppy board level
Page 71 and 72: Camera dimensions Cross section: C-
Page 73 and 74: Camera interfaces Camera interfaces
Page 75 and 76: Camera interfaces Signal Pin Pin Si
Page 77 and 78: Camera interfaces 1 2 3 4 5 6 7 8 9
Page 79 and 80: Camera interfaces Class S1 Error co
Page 81 and 82: Camera interfaces Register Name Fie
Page 83 and 84:
Camera interfaces Register Name Fie
Page 85 and 86:
Camera interfaces IntEna FVal Busy
Page 87 and 88:
Camera interfaces Output modes ID M
Page 89 and 90:
Camera interfaces FPGA Note � Tri
Page 91 and 92:
Camera interfaces Note � Note the
Page 93 and 94:
Camera interfaces Pixel data Pixel
Page 95 and 96:
Camera interfaces (AVT) Y-(K+0) [1
Page 97 and 98:
Camera interfaces (AVT) Y componen
Page 99 and 100:
Description of the data path Sensor
Page 101 and 102:
Description of the data path Readou
Page 103 and 104:
Description of the data path Figure
Page 105 and 106:
Description of the data path 1st fi
Page 107 and 108:
Description of the data path Figure
Page 109 and 110:
Description of the data path This i
Page 111 and 112:
Description of the data path As men
Page 113 and 114:
Description of the data path Color
Page 115 and 116:
Description of the data path White
Page 117 and 118:
Description of the data path Regist
Page 119 and 120:
Description of the data path One-pu
Page 121 and 122:
Description of the data path Note
Page 123 and 124:
Description of the data path The fo
Page 125 and 126:
Description of the data path Regist
Page 127 and 128:
Description of the data path The II
Page 129 and 130:
Description of the data path To con
Page 131 and 132:
Description of the data path Look-u
Page 133 and 134:
Description of the data path Defect
Page 135 and 136:
Description of the data path Buildi
Page 137 and 138:
Description of the data path Send d
Page 139 and 140:
Description of the data path 2 x ve
Page 141 and 142:
Description of the data path 2 x ho
Page 143 and 144:
Description of the data path 2 x fu
Page 145 and 146:
Description of the data path Sub-sa
Page 147 and 148:
Description of the data path Format
Page 149 and 150:
Description of the data path 2 out
Page 151 and 152:
Description of the data path Binnin
Page 153 and 154:
Description of the data path Note
Page 155 and 156:
Description of the data path 0 V 0.
Page 157 and 158:
Description of the data path Settin
Page 159 and 160:
Description of the data path BAYER
Page 161 and 162:
Description of the data path Readou
Page 163 and 164:
Description of the data path To con
Page 165 and 166:
Description of the data path Offset
Page 167 and 168:
Controlling image capture Controlli
Page 169 and 170:
Controlling image capture Electroni
Page 171 and 172:
Controlling image capture Trigger_M
Page 173 and 174:
Controlling image capture IntEna FV
Page 175 and 176:
Controlling image capture Trigger_M
Page 177 and 178:
Controlling image capture The scree
Page 179 and 180:
Controlling image capture Register
Page 181 and 182:
Controlling image capture Exposure
Page 183 and 184:
Controlling image capture Example G
Page 185 and 186:
Controlling image capture # Read/ W
Page 187 and 188:
Controlling image capture ISO_Enabl
Page 189 and 190:
Controlling image capture User prof
Page 191 and 192:
Video formats, modes and bandwidth
Page 193 and 194:
Page 195 and 196:
Page 197 and 198:
Page 199 and 200:
Page 201 and 202:
Page 203 and 204:
Page 205 and 206:
Page 207 and 208:
Page 209 and 210:
Page 211 and 212:
Page 213 and 214:
Page 215 and 216:
Page 217 and 218:
Page 219 and 220:
How does bandwidth affect the frame
Page 221 and 222:
Page 223 and 224:
Page 225 and 226:
Configuration of the camera Far lef
Page 227 and 228:
Configuration of the camera Configu
Page 229 and 230:
Configuration of the camera Offset
Page 231 and 232:
Configuration of the camera Inquiry
Page 233 and 234:
Page 235 and 236:
Page 237 and 238:
Page 239 and 240:
Page 241 and 242:
Page 243 and 244:
Page 245 and 246:
Configuration of the camera Registe
Page 247 and 248:
Page 249 and 250:
Page 251 and 252:
Page 253 and 254:
Page 255 and 256:
Page 257 and 258:
Configuration of the camera Extende
Page 259 and 260:
Configuration of the camera Advance
Page 261 and 262:
Configuration of the camera Camera
Page 263 and 264:
Configuration of the camera Note
Page 265 and 266:
Configuration of the camera Test im
Page 267 and 268:
Configuration of the camera Note
Page 269 and 270:
Page 271 and 272:
Page 273 and 274:
Configuration of the camera MinValu
Page 275 and 276:
Configuration of the camera Mirror
Page 277 and 278:
Configuration of the camera User pr
Page 279 and 280:
Configuration of the camera Stored
Page 281 and 282:
Configuration of the camera The rem
Page 283 and 284:
Configuration of the camera GPDATA_
Page 285 and 286:
Appendix Appendix Sensor position a
Page 287 and 288:
Index Auto_Inq ....................
Page 289 and 290:
Index FORMAT_7_ERROR_2.............
Page 291 and 292:
Index mechanical shutter...........
Page 293:
Index trigger counter (advanced reg
show all

Guppy Technical Manual V7.1.0 - Allied Vision Technologies

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?