0-D Maintenance Mnl, GFZ-62545EN/02 - Automation Service Srl

1. DISPLAY AND OPERATION OF CRT/MDI B–62545EN/021.2POWER–ON SCREENDISPLAY– The CRT screen displays differ slightly between the M and T systems.– The screen displays shown below are for reference purposes only. Someof these displays may not appear depending on the installed options andactual system configuration. Slot state screen0 4 7 1 – 0 5NOT READYAutomatically switched0 4 7 1 – 0 5PMC: XXXX – XXCNC software editionand version displays,which also appearalso on the programlist screenNOT READYIndicates that the servo systemis not ready to operate, that is,it is inoperable.Type of other software in usePMC : Sequence programs created by the machinetool builder– This display does not appear if no other software isavailable.– The displays shown above remain on the screen if the machine is brought to an emergency stop.An ordinary position display is restored when the machine is released from an emergencystop state.6