Safety Standard Certified Ceramic Capacitors/High Voltage ... - Murata

!Note • Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc.• This catalog has only typical specifications. Therefore, please approve our product specifi cations or transact the approval sheet for product specifi cations before ordering.C85E.pdfApr.7,2014DEA Series Specifications and Test MethodsContinued from the preceding page.No.ItemSpecificationsTest Method1315Soldering Effect(On-Preheat)14 TemperatureCycleHumidity (UnderSteady State)16 HumidityLoading17 LifeAppearanceCapacitanceChangeDielectric Strength(Between LeadWires)AppearanceCapacitanceChangeQI.R.Dielectric Strength(Between LeadWires)AppearanceCapacitanceChangeQI.R.AppearanceCapacitanceChangeQI.R.AppearanceCapacitanceChangeQI.R.No marked defectWithin ±2.5%Per item 4.No marked defectWithin ±5%275+5/2C* 2 min. (30pF under)350 min. (30pF min.)1000MΩ min.Per item 4.No marked defectWithin ±5%275+5/2C* 2 min. (30pF under)350 min. (30pF min.)1000MΩ min.No marked defectWithin ±5%275+5/2C* 2 min. (30pF under)350 min. (30pF min.)1000MΩ min.No marked defectWithin ±3%275+5/2C* 2 min. (30pF under)350 min. (30pF min.)2000MΩ min.* 1 "Room condition" Temperature: 15 to 35°C, Relative humidity: 45 to 75%, Atmospheric pressure: 86 to 106kPa* 2 "C" expresses nominal capacitance value (pF).First the capacitor should bestored at 120+0/-5°C for60+0/-5 sec.ThermalScreenCapacitor1.5Then, as in the figure, the leadto 2.0mmwires should be immersed inMoltensolder of 260+0/-5°C up to 1.5 toSolder2.0mm from the root of terminalfor 7.5+0/-1 sec.Post-treatment:Capacitor should be stored for 1 to 2 hrs. at room condition.* 1The capacitor should be subjected to 5 temperature cycles.Step1234Temperature (°C)-25±3Room Temp.125±3Room Temp.Time (min)303303Cycle time: 5 cyclesPost-treatment:Capacitor should be stored for 1 to 2 hrs. at room condition.* 1Set the capacitor for 500+24/-0 hrs. at 40±2°C in 90 to 95%relative humidity.Post-treatment:Capacitor should be stored for 1 to 2 hrs. at room condition.* 1Apply the rated voltage for 500+24/-0 hrs. at 40±2°C in 90 to95% relative humidity.(Charge/Discharge currentV50mA)Post-treatment:Capacitor should be stored for 1 to 2 hrs. at room condition.* 1Apply a DC voltage of 150% of the rated voltage for1000+48/-0 hrs. at 125±2°C with a relative humidity of 50%max. (Charge/Discharge currentV50mA)Post-treatment:Capacitor should be stored for 1 to 2 hrs. at room condition.* 1845