INT'L Shortcut Cartridge Catalogue - Bibus SK, s.r.o.

Cartridge Control Kits
Service Kit
Number
Description
Tri-grip
Handknob Kit
(Plastic)
991-034
Tri-grip
Handknob Kit
with Optional
Maximum Setting
Limiter
35,1 diameter
(Plastic with
aluminium lock
knob)
991-039
Tri-grip
Handknob Kit
(Plastic with
stainless
steel insert)
991-040
Use specifically with
Control/Cartridge
For all Series 1, 2, 3, 4
valves with L or O
adjustment except Series 0 and
counterbalance cartridges.
The handknob can be used
as a Maximum Setting Limiter.
For all Series 1, 2, 3, 4
valves with L or O
adjustment except Series 0 and
counterbalance cartridges.
For all Series 1, 2, 3, 4
valves with L or O
adjustment except Series 0 and
counterbalance cartridges.
This kit should be used in
applications where there is high
vibration and a plastic lock knob
may loosen.
For use with corrosion resistant
cartridge line.
For all Series 1, 2, 3, 4
valves with L or O
adjustment except Series 0 and
counterbalance cartridges.
Install while cartridge is screwed
in cavity to prevent damage.
1
Description Notes
Install while cartridge is screwed in
cavity to prevent damage.
Maximum
19,0 mm
higher than
L adjustment
62 mm
diameter
35,1 mm
diameter
62 mm
diameter
Visit www.sunhydraulics.com for current list pricing and complete technical information on all Sun products.
1
23 mm
23 mm
Aluminium
Lock Knob
23 mm
Nylon
Lock Knob
5
6
1. Do not remove stop ring.
2. Install lock knob by snapping
onto the locknut.
3. Install star knob until contact is
made with the stop ring.
(Caution: During
installation on flow control
valves that have no stop
ring, make sure valve can be
shut with hand knob
installed.)
4. Insert pins in cover so that
they project on backside.
5. Put cover on with inserted pins
and drive pins in until flush
with cover.
When knob is used as a
maximum Setting Limiter:
1. Set valve at desired maximum
setting.
2. Tighten lock nut
(12,5 Nm.).
3. Remove stop ring.
4. Install lock knob.
5. Install handknob until flush
with the lock knob.
6. Insert pins in cover so that
they project on backside.
7. Put cover on with inserted pins
and drive pins in until flush
with cover.
Follow installation instructions
described above.
1. Do not remove stop ring.
2. Install lock knob by snapping
onto the locknut.
3. Install handknob until contact
is made with the stop ring.
(Caution: On flow control
valves that have no stop
ring, ensure that valve can
be shut with handknob
installed.)
4. Insert pins in holes in cover
until they project through.
5. Install cover by driving the
pins into the holes in the
handknob until the pins are
flush with the top of cover.
6. Follow instructions listed
above to install Handknob
when used as a Maximum
Setting Limiter.
Cartridge Control Kits continued on next page.
180 Int’l Shortcut Catalogue #999-901-312