NX-700/700H

REALIGNMENTNX-700/700H1. ModesUser modePanel test modePC modePanel tuning modeData programming mode5. PC Mode5-1. PrefaceThe transceiver is programmed by using a personal computer,programming interface (KPG-46/46A) and programmingsoftware (KPG-111D).The programming software can be used with a PC orcompatible. Figure 1 shows the setup of a PC for programming.Firmwareprogramming modeClone modePC test modePC tuning modePCKPG-46 or KPG-46A orKPG-46A + KCT-46 +Tuning cable(E30-3383-05)Firmware version informationModeUser modePanel test modePanel tuning modePC modeData programmingmodePC test modePC tuning modeFirmwareprogramming modeClone modeFirmware versioninformationFunctionFor normal use.Used by the dealer to check the fundamentalcharacteristics.Used by the dealer to tune the audio.Used for communication between the radioand PC.Used to read and write frequency data andother features to and from the radio.Used to check the radio using the PC.This feature is included in the FPU.Used to tune the radio using the PC.This feature is included in the FPU.Used when changing the main program ofthe flash memory.Used to transfer programming data fromone radio to another.2. How to Enter Each ModeUsed to confirm the internal firmware version.ModeOperationUser modePower ONPanel test mode [ ] + Power ONPC modeReceived commands from PCPanel tuning mode [Panel test mode] + [ ]Firmware programming mode [ ] + Power ONClone mode [ ] + Power ONFirmware version information [ ] + Power ON3. Panel Test ModeSetting method refer to ADJUSTMENT.4. Panel Tuning ModeSetting method refer to ADJUSTMENT.PCD-SUB(25-pin)KPG-46TransceiverKPG-111DPCD-SUB(9-pin)KPG-46ATransceiverFig. 1PCUSBKCT-53UKPG-46ATransceiver5-2. Connection procedure1. Connect the transceiver to the computer using the interfacecable and USB adapter (When the interface cable isKPG-46A, the KCT-53U can be used.).Notes:• You must install the KCT-53U driver in the computer touse the USB adapter (KCT-53U).• When using the USB adapter (KCT-53U) for the first time,plug the KCT-53U into a USB port on the computer withthe computer power ON.2. When the POWER switch on, user mode can be enteredimmediately. When PC sends command the transceiverenter PC mode, and “PROGRAM” is displayed on theLCD.When data transmitting from transceiver, the red LED islights.When data receiving to transceiver, the green LED islights.Note:The data stored in the computer must match the “ModelName” when it is written into the flash memory.5