Using the AMESim MATLAB/Simulink Interface - NUPET

Using the AMESim MATLAB/Simulink Interfaceappropriate text string.Figure 5: Specifying the interface block.Note the three buttons labeled Clear all text, OK and Cancel.• Click on Cancel to abandon the process.• Click on Clear all text to remove any text you have entered.• Click on OK to obtain the icon produced by AMESim.An icon similar to that shown in Figure 6 will appear. Note the port position is denoted by >.Figure 6: The completed interface block.The pointer will take on the appearance of the icon and can be treated like a normalAMESim component icon. Thus it can be mirrored, rotated, deleted or added to systemsketch. All AMESim interface blocks have signal type ports.Connect the block inputs and output to the other components of the model as shown inFigure 2.It is worth mentioning 2 important points:• You can have more than one interface block but if you do, they must all be of thesame type (all Simulink standard interface blocks in the current example);• the AMESim model must be explicit i.e. there cannot be any implicit variables,unless the co-simulation interface is used.10