Using the AMESim MATLAB/Simulink Interface - NUPET

More documents

Recommendations

Info

Table of contentsii
MATLAB/Simulink interface 4.2User ManualUsing the AMESim MATLAB/Simulink Interface1. IntroductionThe AMESim MATLAB/Simulink interface enables you to construct a model of asubsystem in AMESim and to convert it to a Simulink S-Function. The S-Function canthen be imported into Simulink and used within a Simulink system just like any other S-Function.The interface is designed so that you can continue to use many of the AMESim facilitieswhile the model is running in Simulink. In particular you can change the parameters of theAMESim model within AMESim in the normal way, examine the results within AMESimby creating plots just as if they were produced in a regular AMESim run.Normally you will have AMESim and Simulink running simultaneously so that you canuse the full facilities of both packages. The process is illustrated below:Construct the AMESim model as a S-FunctionModify the AMESim submodel parametersComplete the Simulink systemRun the simulationExamine the AMESimsubmodel results in AMESimExamine the Simulink controlsystem results in SimulinkWhen the process is done, the AMESim model parameters may be changed withinAMESim, as well as the Simulink parameters within Simulink. A series of runs can beperformed. Typically, a controller can be designed for the system.Organization of this manualThis manual describes both the standard interface (using the Simulink integrator) and theco-simulation interface (where integrators from both Simulink and AMESim are used).The main part of the manual deals with the standard interface and “Co-simulationinterface”, page 17 looks at the differences between the standard and the co-simulation1
Page 1 and 2: MATLAB/Simulink interfaceVersion 4.
Page 3: Table of contentsMATLAB/Simulink in
Page 7 and 8: 2.2. Supported versions of Simulink
Page 9 and 10: MATLAB/Simulink interface 4.2User M
Page 11 and 12: 3. Constructing the model in AMESim
Page 13 and 14: shown in Figure 4 is produced.Figur
Page 21 and 22: clearly you must adjust the size of
Page 33: MATLAB/Simulink interface 4.2User M
Page 37: MATLAB/Simulink interface 4.2User M

Using the AMESim MATLAB/Simulink Interface - NUPET

Create successful ePaper yourself

Delete template?

Save as template?