C50- PARALLEL PORT INTERFACE CARD Rev. 1 User ... - CNC4PC

More documents

Recommendations

Info

C50 (Rev. 1) User ManualStep 4. Connect the parallel cable coming from the PC to the Female DB25Connector. Note: If this board is not connected to the PC, the outputs and inputs 11, 12, 13,and 15 will be deactivated.Step 5. Connect to the board the components of the system.Step 6. Turn on the external supplies and check that the power led indicator lights.Step 7. Apply 5V to the enable pin to activate the outputs and inputs 11, 12, 13and 15.6. Functional Block Diagrams6.1 Outputs 2-9 simplified block diagramSimplified functional block diagram for the 2-9 pins.Revision: 4/16/2012 http://cnc4pc.com/TechDocs/C50R1_User_Manual.pdf 6/14
C50 (Rev. 1) User Manual6.2 Outputs 1, 14, 16 and 17 simplified block diagramSimplified functional block diagram for the outputs.6.3 Dedicated Inputs simplified block diagramFig. 3 Simplified functional block diagram for the inputs.A Pull-up or Pull-down selection jumper allows selecting the configuration for the alldedicated inputs (pins 10, 11, 12, 13 and 15).Revision: 4/16/2012 http://cnc4pc.com/TechDocs/C50R1_User_Manual.pdf 7/14
Page 1 and 2: C50 (Rev. 1) User ManualC50- PARALL
Page 3 and 4: C50 (Rev. 1) User Manual3. Specific
Page 5: C50 (Rev. 1) User ManualWiring:The
Page 9 and 10: C50 (Rev. 1) User Manual7.2 Connect
Page 11 and 12: C50 (Rev. 1) User ManualCalculating
Page 13 and 14: C50 (Rev. 1) User Manual7.4 Other c

C50- PARALLEL PORT INTERFACE CARD Rev. 1 User ... - CNC4PC

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?