EPSON TM-T88V Technical Reference Guide - Support

Chapter 2 SetupFor Built-in USB InterfaceWhen using the serial or parallel interface, it is not necessary to change the DIP switch settingbut their function changes. For the details, see "For Serial Interface" on page 40 and "For ParallelInterface" on page 42.DIP Switch Bank 1SW Function ON OFFFactorysetting1-1 Auto line feed Always enabled Always disabled OFF1-2 Receive buffer capacity 45 bytes 4 KB OFF1-3 1-6Undefined — OFF1-7 Undefined — *1-8Setting of USB power-savingfunction* Varies depending on the interfaces.Disabled Enabled OFF2DIP Switch Bank 2SW Function ON OFF2-1 Handshaking (BUSY condition) Receive buffer full2-22-3 2-42-5Reserved (Do not changesetting)Selects print densitySets the release condition of thereceive buffer BUSY state. (Thisfunction is effective when DIPSwitch 1-2 is set to off.)* Varies depending on the interfaces.Fixed to OFF Offline Receive buffer fullSee "Selecting the Print Density (DIP Switches2-3/2-4)" on page 45.Releases the BUSYstate when theremaining capacityof the receive bufferreaches 138 bytes.Releases the BUSYstate when theremaining capacityof the receive bufferreaches 256 bytes.Factorysetting2-6 Reserved (Do not changeFixed to OFFOFF2-7 settings)2-8 Reserved — * For DIP Switch 2-1 (BUSY condition), see also "Selecting the BUSY Status" on page 46. Do not change the setting of DIP switches 2-2, 2-6, and 2-7. Otherwise, the printer maynot operate normally.OFFOFFOFFOFF43