Hitachi ZX14-27 -3 - One Call Hire

OPERATING MACHINEBlade and Track Width Control Lever Operation(ZX18-3)dCAUTION:• Be sure to set the track width to either 1280 mm(fully extended) or 970 mm (fully retracted). If themachine is operated with the track width set to adimension other than 1280 mm or 970 mm, thetrack width will not be secured so that the machineupper structure will move unstably.• Never attempt to adjust the track width on a slope.Failure to follow these instructions will cause themachine to turn over or skid, possibly resulting inpersonal injury.IMPORTANT: • Check the sliding surfaces on the trackframe for any accumulated debris. Ifany debris such as soil has accumulated,remove the accumulated debris and cleanthe surfaces.• Check the ground surface under themachine. In case the surface is not flator if any protruding obstructions exist,move the machine to a flat surface area orremove the obstruction before adjustingthe track width.• Do not use the track width control functionto move or tow any objects.Machine failure or damage may result.3132Track-width control switch1ZX18-3(Cab)ZX18-3(Canopy)2Track-widthcontrol switchM1NC-05-014SS4706712M1NC-04-003Blade (When the track-width control switch is OFF:)Use lever (1) to raise and lower the blade.When the lever is released, it automatically returns to itsneutral position, keeping the blade in its position until thelever is operated again.(2) Blade raise(3) Blade lowerTrack width (When the track-width control switch is ON:)Use lever (1) to change the width of the track (undercarriage).When the lever is released, it automatically returns to itsneutral position, keeping the width in its position until thelever is operated again.(2) Narrow width(3) Extend width23M1NC-04-00123M1NC-05-0155-6