Vivotek FD8161 User Manual - Use-IP

VIVOTEK■ Refresh: Click this button to refresh all current connections.■ Add to deny list: You can select entries from the Connection Status list and add them to the Deny Listto deny access. Please note that those checked connections will only be disconnected temporarilyand will automatically try to re-link again (IE Explore or Quick Time Player). If you want to enable thedenied list, please check Enable access list filtering and click Save in the first column.■ Disconnect: If you want to break off the current connections, please select them and click thisbutton. Please note that those checked connections will only be disconnected temporarily and willautomatically try to re-link again (IE Explore or Quick Time Player).Enable access list filtering: Check this item and click Save if you want to enable the access list filteringfunction.Filter TypeSelect Allow or Deny as the filter type. If you choose Allow Type, only those clients whose IP addressesare on the Access List below can access the Network Camera, and the others cannot access. On thecontrary, if you choose Deny Type, those clients whose IP addresses are on the Access List below willnot be allowed to access the Network Camera, and the others can access.FilterThen you can add a rule to the following Access List. Please note that the IPv6 access list column will notbe displayed unless you enable IPv6 on the Network page. For more information about IPv6 Settings,please refer to page 38 for detailed information.There are three types of rules:Single: This rule allows the user to add an IP address to the Allowed/Denied list.For example:52 - User's Manual