Adjustable Frequency AC Drive

Programming and Parameters 3-5Display Group (continued)d012 [Control Source]Related Parameter(s): P036, P038, A051, A052Displays the active source of the Start Command and Speed Command which are normally definedby the settings of P036 [Start Source] and P038 [Speed Reference] but may be overridden by digitalinputs. Refer to the flowcharts on pages 1-18 and 1-19 for details.Start Command Digit 00 = Keypad1 = 3-Wire2 = 2-Wire3 = 2-Wire Level Sensitive4 = 2-Wire High Speed5 = RS485 (DSI) Port9 = JogSpeed Command Digit 10 = Drive Potentiometer1 = A069 [Internal Freq]2 = 0-10V Input/Remote Potentiometer3 = 4-20mA Input4 = A070 - A073 [Preset Freq x](A051 - A052 [Digital Inx Sel] must be set to 4)5 = RS485 (DSI) Port9 = Jog FreqReserved Digit 2Reserved Digit 3Values Default Read OnlyMin/Max: 0/9Display: 1d013 [Contrl In Status]Related Parameter(s): d002, P034, P035Status of the control terminal block control inputs.Important: Actual control commands may come from a source other than the control terminal block.(1)1 = Input Present, 0 = Input Not PresentStart / Run FWD Input (I/O Terminal 02) Bit 0Direction / Run REV Input (I/O Terminal 03) Bit 1Stop Input (1) (I/O Terminal 01) Bit 2Reserved Bit 3The stop input must be present in order to start the drive.When this bit is a 1 the drive can be started.When this bit is a 0 the drive will stop.Values Default Read OnlyMin/Max: 0/1Display: 1