Adjustable Frequency AC Drive

4-6 TroubleshootingDrive does not Start from Start or Run Inputs wired to the terminal block.Cause(s) Indication Corrective ActionDrive is Faulted Flashing red status light Clear fault.• Press Stop• Cycle power• Set A100 [Fault Clear] to option 1“Clear Faults”.• Cycle digital input if A051 - A052[Digital Inx Select] is set to option7 “Clear Fault”.Incorrect programming.NoneCheck parameter settings.• P036 [Start Source] is set tooption 0 “Keypad” or option 5“RS485 (DSI) Port”.• A051 - A052 [Digital Inx Select]is set to option 5 “Local” and theinput is active.Incorrect input wiring.See 1-14 for wiring examples.• 2 wire control requires RunForward, Run Reverse or Joginput.• 3 wire control requires Start andStop inputs• Stop input is always required.Incorrect Sink/Source DIP switchsetting.NoneNoneWire inputs correctly and/or installjumper.Set switch to match wiring scheme.Drive does not respond to changes in speed command.Cause(s) Indication Corrective ActionNo value is coming from the The drive “Run” indicator is lit • Check d012 d012 [Controlsource of the command. and output is 0 Hz.Source] for correct source.• If the source is an analog input,check wiring and use a meter tocheck for presence of signal.• Check d002 [Commanded Freq]to verify correct command.Incorrect reference source isbeing selected via remotedevice or digital inputs.None • Check d012 [Control Source] forcorrect source.• Check d014 [Dig In Status] tosee if inputs are selecting analternate source. Verify settingsfor A051 - A052 [Digital InxSelect].• Check P038 [Speed Reference]for the source of the speedreference. Reprogram asnecessary.• Review the Speed ReferenceControl chart on page 1-18.