052930E-002One Touch non auto - Carefree of Colorado

ONE-Touch 12Volt Patio Awning TroubleshootingAWNING WON'T ROLL OUT/IN(ELECTRICAL)BATTERY MUST BE FULLYCHARGED AND THE RVLEVEL. POLARITY TOCONTROL MODULE MUST BECORRECT OR CIRCUIT WILLNOT WORK. (SEE FIGURE 1)IS THE SWITCH ON?YESNOTURNSWITCH ONCKECK FUSECHECK VOLTAGE AT MOTORCOVER TERMINALS(WITH METER).SEE AWNING WON'TROLL OUT(MECHANICAL)YESIS IT GREATER THAN 11.0VWHILE PUSHING EXTEND/RETRACT SWITCH?NOUNPLUG RAFTERHARNESS PLUG FROMOUTSIDE WALLRECEPTACLE ON RV.APPLY 12 VOLTSDIRECTLY TOTERMINALS ONMOTOR COVERYESDOES AWNING ROLLOUT/IN?NOSEE AWNING WON'TROLL OUT(MECHANICAL)APPLY 12V TORAFTER HARNESSPLUGYESDOES AWNING ROLLOUT/IN?NOCHECK CONNECTIONS INRAFTER PLUG HOUSING.REPAIR OR REPLACEHARNESSRECONNECT RAFTERHARNESS PLUG TO OUTSIDEWALL RECEPTACLE.DISCONNECT 2-PIN MOTORCONNECTOR FROM CONTROLMODULE AND APPLY 12VOLTS TO PINS ON PLUG.(SEE FIGURE 1)NODOES AWNING ROLLOUT/IN?YESCHECK WIRE FOR AT LEAST 14GAUGE. CHECK ALLCONNECTIONS FROM 2-PINMOTOR CONNECTOR TO OUTSIDERECEPTACLE. REPAIR ORREPLACE WIRE CONNECTIONSRECONNECT 2-PIN MOTOR CONNECTOR TOCONTROL MODULE. ADJUST CURRENT LIMITPOT TO UPPER LIMIT. (SEE FIGURE 1)DOES AWNING ROLLOUT/IN?NODISCONNECT 3-PIN CONNECTORFROM CONTROL MODULE.MEASURE FOR CONTINUITYBETWEEN BLACK AND BLUE WIREWHILE DEPRESSING EXTEN/RETRACT SWITCH IN EACHDIRECTION. (SEE FIGURE 1)FIGURE 1REPAIR OR REPLACESWITCH PANELNODOES METER READ 0 ohmsOR 470 ohms?YESRECONNECT 3-PIN CONNECTOR TO CONTROLMODULE. MEASURE VOLTAGE BETWEEN GND.AND +12VDC ON 3-PIN CONNECTOR OFCONTROL MODULE WHILE DEPRESSINGEXTEND/RETRACT SWITCH. SEE FIGURE 1052958-001REPLACE CONTROLMODULEYESIS VOLTAGE GREATERTHAN 11 VOLTS?NOINSPECT WIRING FOR AT LEAST 14 GAUGEFROM POWER SOURCE TO CONTROLMODULE. CHECK ALL CONNECTIONS FROMPOWER SOURCE TO CONTROL MODULE