309244D 50:1 Ratio Double Acting Falcon Grease Pumps - Graco Inc.

InstallationWARNINGA bleed-type master air valve is required in yoursystem to help reduce the risk of serious injury,including splashing in the eyes or on the skin, andinjury from moving parts if you are adjusting orrepairing the pump.The bleed-type master air valve relieves air trappedbetween this valve and the pump after the air isshut off. Trapped air can cause the pump to cycleunexpectedly. Locate the valve close to the pump.1. Install a bleed-type master air valve (B), to relieveair trapped between the valve and the motor. Seethe WARNING above).2. Install an air regulator (C), to control the pumpspeed and pressure.3. Install an air line filter (F) to remove harmful dirtand moisture from the compressed air supply.4. Install a second bleed-type master air valve (G)upstream from all other accessories, to isolate theaccessories for servicing.5. Connect the fluid hose (L) to the dispensevalve (M). Use a gun holder (J) to hold the dispensevalve when not in use.6. For ease in connecting the air line to the pump,use an air line quick disconnect (E) at the pump airinlet.7. Connect the air (D) and fluid hoses (L) to the pump(A). Use only grounded fluid and air hoses. Besure all hoses are properly sized and pressureratedfor your system.NOTE: Additional air line lubrication is not required toextend the Falcon grease pump air motor life. Theair motor is prelubed at the factory and should notrequire additional lubrication between maintenanceschedules. No accessory air line lubricator should beinstalled.