instructions for use SM6 - Schneider Electric

More documents

Recommendations

Info

fitting fuses in aprotected phaseto-earth voltagestep-down transformer(for GBC A3 and GBC B3cubicles only)Remove the plugs protecting thefuse chambers.Connect a wire to each of thecurrent transformersExample : connect on the topConnect a wire to each of thecurrent transformersExample : connect on the downScrew the fuse into the fusechamber.Connect the wire coming from thecurrent step-down transformer.Fit the special nut and tighten itmoderately by hand .7896779EN revision : 01 21
eassemblinga GBM cubicleUse the nuts and bolts previouslyremoved, taking care to fit them intheir original locations.EFA1A2CRefit top plate F and then topplate E.Caution: Make sure that nothinghas been inadvertently left in thebusbar compartment.Refit the front panel C and thenSwivel the angle bracket 90˚to the right.thefrontplateofthetopcompartment A2 and A1.reassemblinga GBC cubicleEFRefit top plate F and then topplate E.Use the nuts and bolts previouslyremoved, taking care to fit them intheir original locations.A1A2CCaution: Make sure that nothinghas been inadvertently left in thebusbar compartment.Refit the front panel C and thenSwivel the angle bracket 90˚to the right.thefrontplateofthetopcompartment A2 and A1.22 7896779EN revision : 01
Page 7: GBC A2 cubicle1 : low voltage conne
Page 10 and 11: handling instructionscubicle identi
Page 12 and 13: handling using a forklift7896779EN
Page 14 and 15: installation and operationrecommend
Page 16 and 17: installation instructionspreparing
Page 18 and 19: assemblingthe switchboardchecks bef
Page 20 and 21: Version ±12 KVbag S6 : 3729746.Mou
Page 24 and 25: low voltage connections(for GBC cub
Page 26 and 27: standard wiringdiagramL1L2L3for vol
Page 28 and 29: maintenance instructionspreventivem
Page 30 and 31: A1A2CConnect the wire coming from t
Page 32 and 33: CAUTIONpump the gas for at least 15
Page 34: group Schneider Electric servicecen

instructions for use SM6 - Schneider Electric

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?