Installation Instructions - Chris Alston's Chassisworks

More documents

Recommendations

Info

45. Torque to 45 lb-ft.46. Repeat the above on the opposite sideof the vehicle.47. Move the rear suspension through its complete range of shock travel, including full compression, fullextension, and full roll in both directions. There should be at least 1” of clearance between the shock bodyand the axle tube at all points.Full CompressionFull ExtensionFull Roll18
48. Once the clearance is checked you can installthe coil springs on the shocks using the VAS-200 spring compressor. Follow the instructionsincluded with the compressor.49. Re-install the coil-overs with springs and torquethe bolts to 45 lb-ft.VariShock Air SpringsAdditional clearance checks are required wheninstalling air springs.• Clearance around the top of the shock forthe port and for the air line to be safelyrouted around any exhaust components ormoving parts.• Clearance around the air bag, including theaxle tube, brake/fuel lines, and exhaust.19
Page 4: 4DRIVER SIDE SHOWN
Page 7 and 8: 3. Jack the car up and place two ja
Page 9 and 10: 11. Bolt the upper coil-over mount
Page 11 and 12: 18. Align the top edge on the coil-
Page 13 and 14: 25. Remove the rear lower control a
Page 15 and 16: Before proceeding, the rearend hous
Page 17: 42. The upper mount and coil-over s
Page 21 and 22: VERIFY RIDE HEIGHT (COIL-OVERS)Afte
Page 23 and 24: 1. Verify that the springs are supp

Installation Instructions - Chris Alston's Chassisworks

Create successful ePaper yourself

Delete template?

Save as template?