13.07.2015 Views

Allegro Bay Owner's Manual - Tiffin Motorhomes

Allegro Bay Owner's Manual - Tiffin Motorhomes

Allegro Bay Owner's Manual - Tiffin Motorhomes

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

MAJOR APPLIANCES & ACCESSORIEStelephone jacks (e.g., living room) for connecting telephone(s), as desired.Water HeaterWarningDO NOT APPLY 120 VAC POWER to or LIGHT the water heater until after the waterheater is filled with water and the water lines and heater tank are purged of any trappedair. Failure to do so will damage the water heater and may cause additional damage tothe motor home.Before the water heater is to be used, first fill the fresh water system and purge the water lines to and from thewater heater by opening all the hot-water faucets until water steadily flows from each one and no “spurting” or“hissing” sounds are further heard. The water heater holds 6 gallons of water and uses either the LP gas systemor the 120-volt AC electrical system to operate the heater.Proper and safe operation of the water heater requires that all safety information provided in the owner’smanual be read and understood before placing the water heater in service. Take the time to becomefamiliar with this manual (provided in the Owner’s Information Package).The water heater is designed for operation either with LP gas or 120-volt AC electricity. Both modes ofoperation are now presented.LP Gas – Electronic Ignition Operation (6-Gallon Model)1. Turn the remote switch to the “on” position.2. If the remote-switch light stays “on” longer than 15 seconds, turn the remote switch to the “off”position and wait 5 minutes.3. Repeat Step One.4. (For 6-Gallon Models only): For complete shutdown and also before any servicing:a. Turn the remote switch to the “off” position.b. Remove the red wire from the left-hand terminal of the ECO switch (ECO to valve).5. If the water heater fails to operate because of high water temperature, the heater will go into a lockoutcondition (indicator light “on”). When the water eventually cools, reset the system by turning theswitch to the “off” position for at least 30 seconds, then turn the switch back “on.”6. If a lockout condition persists, contact your authorized dealer.4-14

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!