13.07.2015 Views

Allegro Bay Owner's Manual - Tiffin Motorhomes

Allegro Bay Owner's Manual - Tiffin Motorhomes

Allegro Bay Owner's Manual - Tiffin Motorhomes

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

120-Volt AC Electrical OperationMAJOR APPLIANCES & ACCESSORIES1. For electrical operation, use the power switch on the water heater; depending on the particular model,that switch may be located either at the front or at the rear of the water heater.2. Completely fill the water heater with water and purge the hot-water lines of any trapped air.3. Turn the power switch located on the water heater “on.” NOTE: Turning the power “on” to thewater heater without having previously covered the water-heating element with water may quickly burnout the element and void the warranty.4. After awhile, check the water heater for proper operation; the water temperature should beapproximately 140°F (60°C).5. If the manual-reset, high-temperature-limit switch should trip the circuit breaker; reset the switch bydepressing the reset button--use a pencil or other non-metallic object to depress the reset button. If thehigh-temperature-limit switch should again trip the circuit breaker, contact an authorized servicetechnician or an authorized dealer.6. Both the electrical and gas operations of the water heater may be used simultaneously to reducerecovery time of heating water up to desired temperature.For general maintenance of the water heater or specific information about select steps in operating the waterheater, please refer to the owner’s manual for this appliance contained in the Owner’s Information Package.WarningDO NOT STORE any combustible or flammable substances near or adjacent to the waterheater. Provide adequate space for ventilation and air circulation.Water Heater StorageIf the motor home is to be stored during the winter months, the water heater should be drained to preventdamage caused by freezing water contained in the water heater. To drain the water heater, first turn “off” allelectrical power, turn “off” the LP gas going to the water heater, then turn “off” the water pump. Open boththe hot- and the cold-water faucets to drain the water lines and open the drain plug on the water heater to drainthe entire system.When re-activating the water heater after the motor home is taken out of storage, make sure that the entirewater system, including the water heater, has been filled with water and the lines have been purged of anyentrapped air before relighting the water heater. Failure to do so may allow the water-heating element to beturned “on” before such is immersed in water; thereby, causing the premature failure of the heating elementand voiding the warranty.4-15

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!