Allegro Bay Owner's Manual - Tiffin Motorhomes

SLIDE-OUT FEATURESManual Operation: Slide-Out RoomYour Power Gear slide-out system is equipped with a manual override that allows one to extend or retract theroom in the event of a loss of power.Please NoteIf the slide-out room doesn’t move when the rocker switch is depressed, check thefollowing:Make sure the ignition switch is turned “off.”Make sure the battery is fully charged and connected.Make sure the slide-out breakers haven’t been “tripped”—these breakers are located onthe firewall.After the previous items have been checked and the slide-out room still does not move when the rocker switchis pressed, follow these simple steps (Figure 8-2) to override the slide-out room manually.1. Turn “off” the ignition switch.2. Locate the slide-out electrical controller (refer to your TiffinMotorhomes dealer or the Tiffin Motorhomes factory for its location).There are two versions of the controller. For version 1, unplug the sixpinwiring harness to the controller. For version 2, remove one of themotor leads (either the motor I or the motor II lead from thecontroller).Figure 8-2. Manual Slide-OutDeployment Sequence3. Locate the slide-out motor; it will be mounted to one side of the slideoutrails. NOTE: If the motor home has an underbelly or a cover overthe motor, these parts must be removed to access the motor.4. Rotate the brake lever, on the backside of the motor, counter-clockwise(CCW) (looking from the rear of the motor) about 1/8 of a turn to thereleased position. This action will release the brake that holds the roomin place.5. Locate the manual override for the slide-out system.6. The room is now free to move. Using a ¾” wrench or socket, crankthe room either “in” or “out” completely (depending on your needs).8-4