welder level c program outline - Industry Training Authority

LINE C:PERFORMS FUSION AND BRAZE WELDING USINGOXY-FUEL PROCESSES (OFW)Competency: C-6 Fusion Weld Stringer Beads and Fillet Welds on LowCarbon Steel SheetLearning Objectives:The learner will fusion weld stringer beads and fillet welds on low carbon steel sheetusing OFW processes.LEARNING TASKS1. Fusion weld stinger beads in theflat position.CONTENT Weld stinger beads without a filler rod inthe flat position - refer to practicalcompetency for Weld ProcedureSpecification (WPS) Weld stinger beads with a filler rod inthe flat position - refer to practicalcompetency for Weld ProcedureSpecification (WPS)2. Fusion weld fillet welds in the flat(1F) position on lap and cornerjoint on low carbon steel sheet.3. Fusion weld fillet welds in thehorizontal (2F) position on lapjoint on low carbon steel sheet.4. Fusion weld fillet welds in thevertical (3F) position on lap jointson low carbon steel sheet.Fillet weld on lap joint in the 1F position- refer to practical competency for WeldProcedure Specification (WPS)Fillet weld on corner joint in the 1Fposition - refer to practical competencyfor Weld Procedure Specification(WPS)Fillet weld on lap joint in the 2F position- refer to practical competency for WeldProcedure Specification (WPS)Fillet weld on lap joint in the 3F position- refer to practical competency for WeldProcedure Specification (WPS)NOTE: Refer To Current Welder Training Program Curriculum Module/Line P3-4.Achievement Criteria:The learner will be evaluated on the ability to fusion weld fillet welds on low carbon steelsheet using OFW processes as part of a practical shop project as per the acceptancecriteria in the current curriculum module/line P3-4; evaluation must meet CSA W59standards for cyclically loaded structures.Welder Level C Program Outline • Industry Training Authority 44