Ford Everest.pdf

Recommendations

Info

Restraint System4. Remove in the order indicated in the table.1 Lower Anchor CoverUpper Anchor Bolt39-78n.m2 Connector3 Bolt4 SeatbeltUpper AnchorCover437.8-10.8n.m2339-78n.m15. Install in the reverse order of removal.6. Turn the engine switch to the ON position.7. Verify that the airbag system warning light illuminates forapproximately 6 seconds and goes out.Adjuster Anchor1. Remove the following parts.1. Rear scuff plate2. Front scuff plate3. Remove the B-pillar lower trim4. Front seatbelt upper anchor cover5. Front seatbelt upper anchor installation bolt6. Remove the B-pillar upper trim2. Remove in the order indicated in the table.139-78n.m1 Bolt2 Anchor Adjuster1239-78n.m3. Install in the reverse order of removal.54Copyright © 2009 <strong>Ford</strong> Motor Company of Southern Africa.
Restraint SystemSeatbelt InspectionBelt1. Verify that the belt is installed properly with no twist or kinks.2. Verify that there is no damage to the seatbelt and no deformation ofmetal fittings.• If there is any malfunction, replace the seatbelt.RetractorELR1. Verify that the belt can be pulledout smoothly, and that it retractssmoothly.• If there is any malfunction,replace the seatbelt.2. Verify that the retractor locks whenthe belt is pulled quickly.• If there is any malfunction,replace the seatbelt.3. Remove the retractor.4. While pulling the seatbelt out,make sure that the seatbelt doesnot lock when the retractor is tiltedslowly up to 15° from the mountedposition and locks when theretractor is tilted 40° or more.• If there is any malfunction,replace the seatbelt.Load Limiter Retractor• When the load limiter operates, the belt and anchor rub againsteach other strongly leaving wear tracks. If the seatbelt is used inthis state, the seatbelt will not function at its full capability andthere is the possibility of serious injury to passengers. Be sure toreplace the seatbelt once the load limiter operates.PullBeltAnchorTraceof Wear1. If the vehicle has been subjected to ashock in an accident, pull the belt fromthe retractor and confirm that there areno wear tracks (the load limiter has notoperated) by visually inspecting andfeeling the belt.• If there is any malfunction,replace the seatbelt.Copyright © 2009 <strong>Ford</strong> Motor Company of Southern Africa. 55
Page 1 and 2:
EverestModel Introduction Training
Page 3 and 4: ContentsOverview 4New Technical Spe
Page 5 and 6: OverviewModels3.0TDCi 4x2 M/T XLTKe
Page 7 and 8: OverviewPower and PerformancePeak T
Page 9 and 10: OverviewFord Everest Dimensions5062
Page 11 and 12: Technical SpecificationsRear Brake
Page 13 and 14: Technical SpecificationsABS Wheel-S
Page 15 and 16: Technical SpecificationsSuspensionF
Page 17 and 18: Technical Specifications4x424.5-36.
Page 19 and 20: Technical Specifications• The rig
Page 21 and 22: BodyWith Manual TransmissionIf the
Page 23 and 24: BodyFront Lift PostRear Lift PostFr
Page 25 and 26: BodyCabin Side Frame Straight Line
Page 27 and 28: BodyPointSymbolDesignationHole Diam
Page 29 and 30: BodyPointSymbolDesignationHole Diam
Page 31 and 32: BodyRear Body Straight Line Dimensi
Page 33 and 34: BodyBody StructurePure SUV stylingT
Page 35 and 36: BodySide Inner Panels84735261910121
Page 37 and 38: BodyGlass1 Rear Window Glass 3 Rear
Page 39 and 40: Body5. Use only glass primer on the
Page 41 and 42: BodyThe Aluminium Anodizing Process
Page 43 and 44: Restraint System• A live (undeplo
Page 45 and 46: Restraint System• If the side air
Page 47 and 48: Restraint SystemAirbag module, pre-
Page 49 and 50: Restraint System4. Install in the r
Page 51 and 52: Restraint System1 Bolt A6.9-9.8n.m1
Page 53: Restraint SystemClock Spring Inspec
Page 57 and 58: Restraint SystemThird-row Seatbelt
Page 59 and 60: WildtrakWildtrak front bumper re-wo
Page 61 and 62: Notes:Copyright © 2009 Ford Motor
Page 63 and 64: Copyright © 2009 Ford Motor Compan
show all

Ford Everest.pdf

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?