INFOBALE - Hjallerup Maskinforretning A/S

More documents

Recommendations

Info

ENNeedle shear bolt alarm:A twine problem is indicated by a flashing light (2).If the display shows: « NEEDLE BOLT » , the needleshear bolt has failed so the twine can no longer betied. Replace the shear bolt. Start tying oncemanually to reset the alarm.Alarm packer overload:Packer overload is indicated by a flashing light (3).The display shows: « FEED OVERLOAD » .Stop the baler and reduce the pto rpm, so theoverload clutch can engage again. If this clutchdoes not engage anymore, then stop the pto andremove the cause of the problem. If the clutch slips,the forward speed must be adapted.Communication alarm:There is a communication problem between thebaler control box and the control box in the tractor.Information on display: « COMMUNICATION » .Consult your dealer.Switching off one of the above alarms:Pressdisplay.once to remove the information from theIn all case the lights remain blinking until theproblem has been solved.Caution: In the event of a recurring message thecause must be traced and remedied.10© Kverneland
EN5) Electric emergency control densitypressureIn the event of an electronic problem, the<strong>INFOBALE</strong> control system still offers a possibility tocontrol the density pressure.Put the main switch under the control box inposition (II). The density pressure can be increasedwith the emergency switch on the sideuntil the required setting has been reached on thepressure gauge. Repeat this procedure regularly(every 30 sec, depending on frequency of readingthe manometre). Now the operator can read thedesired pressure from the pressure gauge. Themaximum density pressure is set by rotating thehandwheel of the proportional valve on thehydraulic valve block (V5)! This procedure mustNEVER be performed during work!Caution: The emergency density pressure controlmakes it possible to continue work despiteelectronic problems. It remains important to remedythe problem quickly. Quick and proper baleroperation requires that the machine runs with the<strong>INFOBALE</strong> control system with the main switch inposition (I).© Kverneland11
Page 1 and 2: Operation manualINFOBALE+-G0203GPR(
Page 3 and 4: This operation manual contains the
Page 5 and 6: EN1.2) Building inMount the INFOBAL
Page 7 and 8: EN2) Working with the high density
Page 9 and 10: EN3) Baling processCaution: it is v
Page 11: EN4) Fault messagesCaution: When th
Page 15 and 16: EN7) Factory FunctionsSimultaneousl
Page 17 and 18: EN• ML- max. setting • 500 = gr
Page 19 and 20: EN- Needle frame shear bolt sensor-
Page 21 and 22: EN© Kverneland19
Page 23 and 24: EN10) Trouble shooting tableCaution
Page 25: KVERNELAND GELDROP BVNuenenseweg 16

INFOBALE - Hjallerup Maskinforretning A/S

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?