INFOBALE - Hjallerup Maskinforretning A/S

More documents

Recommendations

Info

1) Electric control “Infobale”The high density baler comes with electronic control.This system controls and monitors the bale growth,the tying process and the pressure control. Thesystem also features fault message functions. Thecontrol box allows the operator to control the entirebaling process from the tractor. The main functionsthat are monitored include:- Plunger load- Knifes position- Packer overload- Twine position and operation tying needleSensorsBecause the Infobale system features extensivemonitoring functions, the high density baler isequipped with a number of sensors. The followingsensors are used on the baler:- proximity sensors- analog sensors1.1) Infobale1 Control box2 Connection cable control box3 Power cable 12V4 PTO sensor5 Valve block hydraulics6 Plunger load sensor ML7 Fans knotter cleaning8 Emergency stop fans9 Tying sensor10 Needle frame shear bolt sensor11 Twine sensor12 Machine casing13 Feed fork safety sensor FF14 Knife position sensor OC2© Kverneland
EN1.2) Building inMount the <strong>INFOBALE</strong> control box (1) in the tractorcab within reach and view of the operator. The boxhas an on/off switch (2), a display and functionkeys.<strong>INFOBALE</strong> control system must be switched off andthe power cables must be pulled out.The machine casing (3) on the baler has a balergearedcontrol system.Connect the power cable (4) to the battery.Connect cable (5) to the control box.Fuses- Monitoring and control box F1:1 x 2 A- Machine control F2:1 x 15 A (outputs and processors)1 x 30 A (fans and 12V output)When connecting the power cable to the battery,note the correct polarity.(+): brown cable(-): blue cableNever connect the cable to the cigarette lighter(interference risk), always directly to theinterference-free power source (check thefunctioning of the fuses on the power cables).Keep cables away from hot and moving parts.When unhitching the machine from the tractor, theconnectors of cables (4) and (5) must always bepulled out and placed in the special holder. Whenthe machine is not used for an extended period, the© Kverneland3
Page 1 and 2: Operation manualINFOBALE+-G0203GPR(
Page 3: This operation manual contains the
Page 7 and 8: EN2) Working with the high density
Page 9 and 10: EN3) Baling processCaution: it is v
Page 11 and 12: EN4) Fault messagesCaution: When th
Page 13 and 14: EN5) Electric emergency control den
Page 15 and 16: EN7) Factory FunctionsSimultaneousl
Page 17 and 18: EN• ML- max. setting • 500 = gr
Page 19 and 20: EN- Needle frame shear bolt sensor-
Page 21 and 22: EN© Kverneland19
Page 23 and 24: EN10) Trouble shooting tableCaution
Page 25: KVERNELAND GELDROP BVNuenenseweg 16

INFOBALE - Hjallerup Maskinforretning A/S

Create successful ePaper yourself

Delete template?

Save as template?