INFOBALE - Hjallerup Maskinforretning A/S

More documents

Recommendations

Info

EN• ML = Machine Load sensor • Current value• Twine sensor • Current value• PTO test • 0 = no signal• 1 = signal• FF (packer) test • 0 = no signal• 1 = signal• Bind = tying needle • 0 = no signal• 1 = signal• Opticut • 0 = no signal• 1 = signal• Needle frame shear bolt • 0 = no signal• 1 = signal• Keyboard test screen for keysand LEDs• Start F- menu• Press a key —> The key numberappears on the display and theLED will go out. Press a key twiceto return to the basic screen.• Menu selection test / settings • Settings - menu is selected• On-board computer softwareversion• V1.07 19 – 07 – 00 = softwareversion• Implement software version • V1.07 19 – 07 – 00 = softwareversion• PIN code • Not available• ML- offset • 287 = current (counts) of sensor• 170 = setting for ML sensor if noload)14© Kverneland
EN• ML- max. setting • 500 = growth bar on display isfully black• nb >600 = ML alarm• Total number of bales producedon the machine• Last screen Settings© Kverneland15
Page 1 and 2: Operation manualINFOBALE+-G0203GPR(
Page 3 and 4: This operation manual contains the
Page 5 and 6: EN1.2) Building inMount the INFOBAL
Page 7 and 8: EN2) Working with the high density
Page 9 and 10: EN3) Baling processCaution: it is v
Page 11 and 12: EN4) Fault messagesCaution: When th
Page 13 and 14: EN5) Electric emergency control den
Page 15: EN7) Factory FunctionsSimultaneousl
Page 19 and 20: EN- Needle frame shear bolt sensor-
Page 21 and 22: EN© Kverneland19
Page 23 and 24: EN10) Trouble shooting tableCaution
Page 25: KVERNELAND GELDROP BVNuenenseweg 16

INFOBALE - Hjallerup Maskinforretning A/S

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?