INFOBALE - Hjallerup Maskinforretning A/S

EN3) Baling processCaution: it is vital to let the machine run at nominalspeed during use. Only then can flawless operationof the various functions be guaranteed.The forward speed (choice of gear) must always beadapted to the swath width. To achieve maximumbale density, the separate wads in the bale must notbe thicker than 5 cm. If large quantities regularlycause feeder overload, then the forward speed mustbe reduced.Adapt the forward speed to the number ofcompression strokes per bale. The working screenshowing the plunger strokes per bale is a good toolhere.Examples:Bale growth per plunger stroke can be estimated onthe basis of the compression time per bale. theplunger makes 45 compression strokes/min at1000 rpm. Allow for turning at the headland andstopping in the field.bale length(in cm) 80 120 160 180 200 220 240 250 260no strokes per bale 16 24 32 36 40 44 48 50 523.1) Setting the hydraulic densitypressureThe operator has to set the hydraulic densitypressure.= increase pressure= decrease pressureAdapt the density pressure to the conditions(material, crop humidity, swath shape, twinestrength etc.).Caution: The maximum density pressure is 170 bar.Let the pto run so the hydraulic pressure can beread from the pressure gauge.© Kverneland7