881 and 881CT Cam Track Hydraulic Benders

More documents

Recommendations

Info

Assembly and Operation Instructions881 and 881CT with 1813 Bending Table (cont’d)881 and 881CT Cam Track ® Hydraulic BendersSTART17. Insert the follow bar into the bender with the endmarked START, as shown.19 and 20. Insert the ram positioner (33).18. Support the rear of the follow bar on the pipevise unit.21. Attach the hydraulic fitting unit (29) to the ram, andconnect the hose to the fitting unit. Set the cylinderand yoke unit on the follow bar. Rotate the pumpcontrol lever counterclockwise.
Assembly and Operation Instructions881 and 881CT with 1813 Bending Table (cont’d)881 and 881CT Cam Track ® Hydraulic Benders22. Activate the hydraulic pump to extend the ramapproximately 14 inches. DO NOT OVER EXTEND.Attach the yoke to the ram positioner with the yokepin (G). Secure the yoke pin with a hitch pin clip (E).23. Insert one cylinder block pin (F) into the hole marked3" CONDUIT as shown.24 and 25. Swing the ram unit into position.
Page 1 and 2: INSTRUCTION MANUAL881 and 881CT Cam
Page 3 and 4: 881 and 881CT Cam Track ® Hydrauli
Page 5 and 6: Identification—Major Components88
Page 7 and 8: Assembly and Operation Instructions
Page 13: Assembly and Operation Instructions
Page 23 and 24: Laying Out One-Shot 90° Bends881 a
Page 25 and 26: Laying Out Two-Shot 90° Bends for3
Page 29 and 30: Special Bending Information Chart88
Page 31 and 32: Special Bending Information Chart (
Page 35 and 36: Identification—Major Components88
Page 37 and 38: Shoe Groups for the 881 and 881CT88
Page 39 and 40: Shoe Groups for the 881CT Only881 a
Page 41 and 42: Parts List—Ram (502 7416.3)881 an
Page 43 and 44: Parts List—1813 Bending Table (50

881 and 881CT Cam Track Hydraulic Benders

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?