881 and 881CT Cam Track Hydraulic Benders

Assembly and Operation Instructions881 and 881CT with 1813 Bending Table (cont’d)881 and 881CT Cam Track ® Hydraulic Benders26. Remove the cylinder block pin from the 3 inchconduit hole in the connecting bar. Rotate the pumpcontrol lever clockwise to retract the ram. Positionthe cylinder block at the proper location for the sizeof conduit to be bent. Insert the two cylinder blockpins (F) through the connecting bars and through thecylinder block. Secure the pins with two hitch pinclips (E).28. Remove the ram positioner from the connectingbar unit.SADDLE PIN29. Load the shoe into the bender with the saddle pinhole to the left, as shown.27. Remove the yoke pin from the ram positioner.