881 and 881CT Cam Track Hydraulic Benders

881 and 881CT Cam Track ® Hydraulic BendersTroubleshooting (cont’d)PROBLEM PROBABLE CAUSE PROBABLE REMEDYWrinkling of IMC or rigid. Follow bar is in backwards. Remove follow bar and insert endmarked START toward saddle.Side creasing of IMC or rigid. Conduit is not level (when bending Level the conduit.on floor).Follow bar not centered on roller atstart of bend.Center the follow bar on the roller.Won’t bend IMC or rigid. Shoe pin in wrong position. Move shoe pin to hole markedIMC/RIGID.Follow bar is in backwards.Remove follow bar and insert endmarked START toward saddle.Ram will not advance. Pump does not have enough oil. Add oil. See instructions supplied withthe pump.Pump vent is closed.Hose couplings not fully tightened.Excessive voltage drop from longextension cord.Open the pump vent.Tighten the hose couplings.Use a shorter or heavier extension cord.