Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Amplified Audio systems<br />
For half or fully amplified systems you will need to use an Autoleads SOT accessory lead which can be<br />
purchased from the supplying dealer or to check your vehicle compatibility please visit: www.my-io.com<br />
Please see the following diagrams for connecting to a system that uses external amplifiers.<br />
ISO<br />
CONTROL BOX<br />
(Bottom View)<br />
Audio Mute<br />
HF Mute<br />
Fig. 16 - Fully Amplified System<br />
ISO<br />
CONTROL BOX<br />
(Bottom View)<br />
iPod<br />
Audio Mute<br />
HF Mute<br />
Fig. 17 - Half Amplified System<br />
iPod<br />
Head Unit Factory Mute<br />
To Head Unit<br />
Mute Input (neg)<br />
Head Unit Factory Mute<br />
To Head Unit<br />
Mute Input (neg)<br />
SOT 1000 Range<br />
+12V Ignition (If required)<br />
Vehicle Speci�c Plug<br />
To<br />
Head Unit Plug<br />
To Vehicle<br />
Original Loom<br />
Some vehicles do not include an accessory or ignition wire in the standard radio harness so you will need<br />
to route the red wire on the harness to a switched 12V accessory or ignition source. This can often be<br />
found at the cigarette lighter but please verify with a multi-meter before making the connection. On CAN or<br />
Multiplex systems please refer to your vehicle manufacturer for a safe accessory pickup point as incorrect<br />
connection can cause error codes or other damage to the vehicle.<br />
AMI-030<br />
SOT 1000 Range<br />
AMI-030<br />
+12V Ignition (If required)<br />
Vehicle Speci�c Plug<br />
To<br />
Head Unit Plug<br />
To Vehicle<br />
Original Loom<br />
17
Change language