USER MANUAL - iO Talk & iO Play

Enabling eSCO
If your phone supports eSCO (enhanced SCO) you are able to configure the kit to connect to it using this
profile.
Using the eSCO function can improve the call quality both at the near and far end.
This option can be found in the following menu.
Menu settings Bluetooth enable esCO On / Off
Once you have changed this selection you will be required to reboot the kit to activate the change. This
can be done by turning the ignition off and then on again or by using the reboot function in the advanced
menu section.
Please note that if this option is enabled then it will be active on ALL phones connected to the kit even if
they do not support eSCO.
If you are using a phone that does not support the eSCO profile you may find that you experience difficulty
in making and receiving calls from that device
In this scenario you should disable eSCO. The default setting is ‘OFF’
Ringtone
For phones that do not support ‘in-band’ ringtones (the phones internal ringtone) one of 5 preset ringtones
can be selected to alert you to an incoming call. If your phone does support ‘in band’ ringing the iO Kit will
automatically use the phones ringtone. Please check your handsets user guide for information.
The default setting is to use the phones ringtone where this is available, if not then tone 1 will be used as
the default. When a ringtone option is highlighted you will hear a demo of that tone. To select the tone
click the rotary control.
Menu settings Ringtone Choose Ringtone
system Volume
The main volume of the system can be adjusted in this menu. This volume controls the TTS
announcements and can be adjusted independently from other volumes. If TTS is turned on then you
will hear a vocal confirmation of each volume step up or down. If TTS is turned off then a beep will be
transmitted each time the volume is changed.
Menu settings system Volume Increase / decrease
41