Instruction manual - Emotron

2.2 Stand-alone units
The AC drive must be mounted in a vertical position against
a flat surface. Use the template (in the File archive on our
homepage) to mark out the position of the fixing holes.
Fig. 4 AC drive mounting model 003 to 3K0
2.2.1 Cooling
Fig. 4 shows the minimum free space required around the
AC drive for the models 003 to 3K0 in order to guarantee
adequate cooling. Because the fans blow the air from the
bottom to the top it is advisable not to position an air inlet
immediately above an air outlet.
The following minimum separation between two AC drives,
or a AC drive and a non-dissipating wall must be
maintained. Valid if free space on opposite side.
Table 4 Mounting and cooling
FDU-FDU
(mm)
FDU-wall,
wall-one
side
(mm)
003-018 026-074 090-250 300-3K0
cabinet
a 200 200 200 100
b 200 200 200 0
c 0 0 0 0
d 0 0 0 0
a 100 100 100 100
b 100 100 100 0
c 0 0 0 0
d 0 0 0 0
NOTE: When a 300 to 3K0 model is placed between two
walls, a minimum distance at each side of 200 mm must
be maintained.
2.2.2 Mounting schemes
128.5 37
Fig. 5 FDU48/52: Model 003 to 018 (B)
Fig. 6 Cable interface for mains, motor and communication,FDU48/52:
Model 003 to 018 (B)
Fig. 7 FDU48/52: Model 003 to 018 (B), with optional
gland plate
12 Mounting CG Drives & Automation, 01-5325-01r1
416
Glands
M20
Glands
M32
202.6
10
396
Ø 13 (2x)
Ø 7 (4x)
Gland
M16
Gland
M25