GPFS: Administration and Programming Reference - IRA Home

mmlsconfig Command
Name
mmlsconfig – Displays the current configuration data for a GPFS cluster.
Synopsis
mmlsconfig
Description
Use the mmlsconfig command to display the current configuration data for a GPFS cluster.
Depending on your configuration, additional information that is set by GPFS may be displayed to assist in
problem determination when contacting the IBM Support Center. If a configuration parameter is not shown
in the output of this command, the default value for that parameter, as documented in the mmchconfig
command, is in effect.
Parameters
NONE
Options
NONE
Exit status
0 Successful completion.
nonzero A failure has occurred.
Security
You must have root authority to run the mmlsconfig command.
You may issue the mmlsconfig command from any node in the GPFS cluster.
When using the rcp and rsh commands for remote communication, a properly configured .rhosts file must
exist in the root user’s home directory on each node in the GPFS cluster. If you have designated the use
of a different remote communication program on either the mmcrcluster or the mmchcluster command,
you must ensure:
1. Proper authorization is granted to all nodes in the GPFS cluster.
2. The nodes in the GPFS cluster can communicate without the use of a password, and without any
extraneous messages.
Examples
To display the current configuration data for the GPFS cluster that you are running on, issue this
command:
mmlsconfig
The system displays information similar to:
Configuration data for cluster cluster1.kgn.ibm.com:
------------------------------------------------------------
clusterName cluster1.kgn.ibm.com
clusterId 680681562214606028
200 GPFS: Administration and Programming Reference