Carnival Castle

276
N3
384
20 1/2"
277
Step 1
24"
19 1/2"
LADDER
BOTTOMS
Rung Ladder Assembly
1. Place Castle Rung Ladder Leg (277) on a flat surface with the pipe holes facing up. Remove any
objects from underneath the Castle Rung Ladder Leg to prevent scarring of the wood.
*NOTE: Do not directly hit the wood or the Ladder Pipes (N3) with a hammer. Use Pipe
Block (384) with a 3-pound (or larger) sledge hammer.
2. Using Pipe Block (384) and a sledge hammer, pound each Ladder Pipe (N3) into the Castle Rung
Ladder Leg (277). Pound the inside three Ladder Pipes (N3) into the wood so they protrude
approximately 19 1/2" from the wood and the outside two Ladder Pipes (N3) approximately 20 1/2"
from the wood.
*NOTE: Ensure Middle Step/Rung Ladder Leg (276) is oriented properly (as shown in INSET
A). The centers of the first rung holes from Ladder Bottoms should measure 8 7/16".
*SUGGESTION: Use a bar clamp to hold ladder together while pounding on second ladder leg.
3. Position Middle Step/Rung Ladder Leg (276) on top of the installed Ladder Pipes (N3). Using a
sledge hammer, pound the Middle Step/Rung Ladder Leg (276) onto the Ladder Pipes (N3).
When properly assembled, the ladder should have a width of 24".
SURFACES
FLUSH
8 7/16"
8 7/16"
N3 277
19
276
INSET A
276
277
9 9/16"
18"
277