Carnival Castle

Step 24
20"
281
19"
384
Monkey Bar and
Monkey Bar Support Assembly
1. Place the Right Monkey Bar Arm (281) and one Monkey Bar Support Leg (280) on a flat surface
with the pipe holes facing up. Remove any objects from underneath the wood parts to prevent
scarring of the wood.
*NOTE: Do not directly hit the wood or the Ladder Pipes (N3) with a hammer. Use Pipe
Block (384) with a 3-pound (or larger) sledge hammer.
2. Using Pipe Block (384) and a sledge hammer, pound each Ladder Pipe (N3) into the Right
Monkey Bar Arm (281). Pound the four inside Ladder Pipes (N3) into the wood so they protrude
approximately 19" from the wood and the two outside Ladder Pipes (N3) approximately 20" from
the wood.
3. Repeat part 2 for the Monkey Bar Support Leg (280).
*SUGGESTION: Use a bar clamp to hold Monkey Bar together while pounding on second
Monkey Bar Arm.
4. Position Left Monkey Bar Arm (282) on top of the installed Ladder Pipes (N3). Using sledge
hammer and Pipe Block (384), pound the Left Monkey Bar Arm (282) on to the Ladder
Pipes (N3). When properly assembled, the Monkey Bar should measure 23" from outside face to
outside face.
5. Repeat part 4 to complete the Monkey Bar Support assembly. The Monkey Bar Support assembly
should have a width of 23" from outside face to outside face when properly assembled.
N3
N3
23"
280
43
23"
384
282
N3
281
280
N3
280