GASPARDO Seminatrici SpA - Opico
GASPARDO Seminatrici SpA - Opico
GASPARDO Seminatrici SpA - Opico
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
66<br />
ENGLISH<br />
INDEPENDENT SYSTEM<br />
When the characteristics of the tractor are such that they cannot<br />
guarantee the correct working of the blower, it is necessary to<br />
install a self-contained oleodynamic system.<br />
Installation characteristics<br />
- Oil supply: follow the data in the table in Fig. 62.<br />
Operation description<br />
The multiplier joined to the tractor’s power take-off, works a pump<br />
that takes oil from the outside tank to the three-way regulator.<br />
Here, indicated on the manometer, the pressure required for the<br />
motor to work the blower is adjusted (Table 6). Furthermore, the<br />
system is equipped with a safety valve that allows the blower to<br />
continue to rotate from inertia without suffering breakage or<br />
damage, if the circulation were to stop suddenly.<br />
Starting up<br />
With the engine off and the tractor immobilized, connect correctly<br />
the quick-couplings. Clean and grease the tractor power takeoff.<br />
(A Fig. 63). Connect the multiplier (B Fig. 63) to the machinery<br />
power take-off as shown in figure 63. Make sure it is correctly<br />
coupled, block the rotation of the multiplier with the chains supplied<br />
(C Fig. 63). Check the multiplier oil level and top up if necessary<br />
(ESSO SAE W80-90). Start the tractor and run the system at idle<br />
for a few minutes, bringing constant pressure to the entire circuit<br />
in order to avoid instability of the blower. Bring the blower up to<br />
the number of revolutions that corresponds to the working<br />
conditions (Tabella 5).<br />
ATTENTION<br />
When it is not intended to distribute product, but rather to use<br />
only the equipment to which it is applied, disconnect the pump<br />
and the multiplier from the rear power take-off and replace it<br />
in the special attachment.<br />
USE AND MAINTENANCE<br />
fig. 63<br />
g<br />
A - tank;<br />
B - multiplier;<br />
C - pump;<br />
D - three way regulator;<br />
E - monometer;<br />
F - engine;<br />
G - safety valve;<br />
H - cooler;<br />
I - filter.<br />
fig. 62<br />
A<br />
B<br />
E<br />
D<br />
B C<br />
C<br />
A<br />
F<br />
G<br />
H<br />
GRUPPO MP 10<br />
RAPP. 1 :2<br />
COD. 6072.002020<br />
OLIO SAE 90<br />
cod. 19502240<br />
I