ATH-Heinl Bedienungsanleitung M72Z Plus

Check whether the assembly head is in the correct position for the
wheel rim. If necessary, set it up as described in the subsection
“Setting up the assembly head”.
Now place the tyre on the wheel rim at an angle so that the
assembly head does not touch any parts of the tyre when
swivelling.
Swivel the assembly tower by pressing the corresponding pedal.
Position the tyre so that the tyre bead is under the nose, but still on
the guideway of the assembly head.
When doing so, ensure that the tyre is opposite the assembly head
in the wheel rim depression.
Start the rotational movement of the clamping plate.
During the assembly process, ensure that the bead run is correct.
Failing to ensure this can cause serious damage to the tyre.
When assembling the second bead, follow the exact same
procedure as for the first bead.
You must also ensure that the tyre is positioned correctly in relation
to the assembly head.
If necessary, position the pneumatic assembly finder slightly
downwards so that the bead cannot pop out.
!!! ATTENTION later pressing down ONLY with the finger can
damage the mounting head !!!
Then position the rim flange protector at the height of the tire
valve. Secure the position with the rim clamp.
Now position the bead hold-down device and both hold-down rollers
as shown opposite.
As soon as the traction point of the tire is more than 180 ° in
relation to the mounting head, the pressure on the tire can be
slowly reduced.
® Copyright ATH-Heinl GmbH & Co. KG, All rights reserved / Misprints and technical changes reserved / As of: 2021-04
Manufacturer ATH-Heinl GmbH & CO.KG
- 20 -