MD-500
MD-500
MD-500
Sie wollen auch ein ePaper? Erhöhen Sie die Reichweite Ihrer Titel.
YUMPU macht aus Druck-PDFs automatisch weboptimierte ePaper, die Google liebt.
Besides, in the table - second column- is mentioned how<br />
the starting size by means of the same change wheels can<br />
be adjusted.<br />
Inch<br />
n/inch AB C<br />
48 70 79<br />
40 70 84 79<br />
32105 98 49<br />
2 4 98 40<br />
2 0 70 84 40<br />
16 56 84 40<br />
14 49 105 50<br />
1249 98 40<br />
11 49 105 39<br />
8 50 105 28<br />
Tab.5<br />
MAINTENANCE<br />
Make sure that the machine is not live when<br />
carrying out maintenance work on the benchlathe<br />
LUBRICATING SCHEDULE<br />
Fig.18<br />
Part<br />
Roller bearing<br />
main shaft<br />
Bearings and cog<br />
wheels of speed<br />
reduction axles in<br />
the headstock (2)<br />
Bearings V-belt<br />
roller and axle<br />
mediate<br />
Thrust bearing<br />
mission (13)<br />
Change gear<br />
wheels (12)<br />
Gear wheels lock<br />
with gear<br />
rack(15)<br />
Gear wheel<br />
bearings lock<br />
case, lock nut<br />
mechanism (17)<br />
Transmission/<br />
starting axle (18)<br />
Sliding surfaces<br />
off the bed (3)<br />
Support spindles<br />
(8, 16)<br />
All ball nipples<br />
the (5,6,9,14 and<br />
20)<br />
Felt in chips<br />
bulldozers (4)<br />
All remaining<br />
white parts<br />
without cover<br />
layer<br />
Tab.6<br />
Time/interval<br />
After first 10 days<br />
after 20 days and<br />
then each 60 days<br />
Annually<br />
Annually<br />
At change or<br />
Weekly<br />
Weekly<br />
Daily<br />
The same<br />
The same<br />
The same<br />
The same<br />
The same<br />
Weekly<br />
Lubricant<br />
Transmission oil<br />
SAE90:<br />
till sight-glass is half<br />
full(1) or lowest cog<br />
wheels just in the<br />
oil<br />
The same<br />
Universel gear<br />
The same<br />
Fine lubricating oil<br />
The same<br />
The same<br />
The same<br />
The same<br />
The same<br />
Vaseline<br />
Maintenance of the machine happens for preventing rust<br />
and wear end tear. The maintenance consists mainly of<br />
clearing and oiling. It certainly is not sufficient to handle<br />
only the oil-syringe. Chips and waste of the machine<br />
parts have to be removed very regularly, often more<br />
times during turning. Otherwise there is the possibility it<br />
lands between moving, slipping and turning parts. For<br />
this reason chips bulldozers on the cross slide have been<br />
placed. watch fig.18.<br />
12 Ferm<br />
Ferm 65
Change language