102386 Kurzbedienungsanleitung FOCX32 ... - Elcon Systemtechnik
102386 Kurzbedienungsanleitung FOCX32 ... - Elcon Systemtechnik
102386 Kurzbedienungsanleitung FOCX32 ... - Elcon Systemtechnik
Sie wollen auch ein ePaper? Erhöhen Sie die Reichweite Ihrer Titel.
YUMPU macht aus Druck-PDFs automatisch weboptimierte ePaper, die Google liebt.
2 Installation of the ELCONnect coax <strong>FOCX32</strong><br />
2.1 Scope of delivery<br />
30<br />
• 1 ELCONnect coax <strong>FOCX32</strong><br />
with 230 V power pack: Order no. 900134<br />
with remote power supply module: Order no. 900178<br />
• 1 toolkit bag<br />
o 3 dowels, 3 screws<br />
o 3 angle brackets for wallmounting incl. screws<br />
o 4 safety fuses for switching the remote-fed sections<br />
• 1 installation manual<br />
• 1 drilling template<br />
<strong>FOCX32</strong><br />
By default the ELCONnect coax <strong>FOCX32</strong> has been preconfigured with a cable feedthrough<br />
for the optical fiber and two PG11m-Ff connection adapters, but any type of adapters with<br />
PG11-screwing can be used. To this see chapter 2.5.<br />
2.2 Mounting instructions<br />
The device shall be assembled according to EN50083-1 / EN60728-11.<br />
The potential equalization of the housing has to be effected through 4 mm²<br />
copper wire at the local earth connection point.<br />
Remote-fed devices must be operated in closed plants. In failure cases the device<br />
housing may be under voltage. For mounting it is therefore necessary to<br />
mark the device accordingly by applying respective safety signs (flash symbol<br />
and “Do not touch” note).<br />
2.3 Selecting the installation place / Fixing the equipment<br />
When observing the applicable installation guidelines, and provided the device has been assembled<br />
correctly, the housing complies with the requirements of safety degree IP54 (5 – protection<br />
against penetration of tools and wires (with diameter > 1 mm) and dust settlement / 4 –<br />
all-side splash-proofness ). With this, the ELCONnect coax <strong>FOCX32</strong> is well-suited for being<br />
used in closed rooms. The device may also be operated in damp rooms and weatherproof exterior<br />
places (e.g. in cable distributors [so-called “feeder distribution interfaces”]). Hereby it is<br />
necessary to ensure respective protection against accidental contact.<br />
The device has not been designed for exterior use without adequate protection<br />
against direct environmental impacts.<br />
The device can be wallmounted and fixed on vertical plain surfaces. The cable holes with the<br />
adapter connectors for the in- and outlets shall point to the bottom, whereas the mains connection<br />
shall point to the right.<br />
Version: 2009/01/29